ATMega_2560_Embedded_THT/PWM_Module/PWM_deadtime/readme.txt

34 lines
1.8 KiB
Plaintext
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

Registers involved:
GPIO:
DDRB: Data Direction Register for Port B= 0xFF for output
PWM Module:
OCR0A: Output Compare Register A=Value here is compared with the Timer value,and when the value matches, the specific pin[pin OC0A(pin 13) in this case] gets toggled
TCCR0A: Timer/Counter 0 Control Register A = 0x83
Bit [7:6]= COM0A-Compare Output Mode A = 10-Non-inverting PWM-Clear OC0A on Compare Match
Bit [1:0]= WGM[1:0]- Waveform Generation Mode=11- for non-inverting fast PWM.
TCCR0B: Timer/Counter 0 Control Register B = 0x03
Bit [2:0] CS0[2:0]-Clock Select = 011- for prescaler=64 in order to obtain frequency of 1kHz
OCR2A: Output Compare Register A=Value here is compared with the Timer value,and when the value matches, the specific pin[pin OC2A(pin 10) in this case] gets toggled. The value given here is such that the duty cycle is 47 percent, a little less than 50 percent. This change in duty cycle is done in order to induce deadtime in the inverted signal.
TCCR2A: Timer/Counter 2 Control Register A = 0xC3
Bit [7:6]= COM0A-Compare Output Mode A = 11-Inverting PWM-Clear OC2A on Compare Match
Bit [1:0]= WGM[1:0]- Waveform Generation Mode=11- for fast PWM.
TCCR2B: Timer/Counter 2 Control Register B = 0x04
Bit [2:0] CS0[2:0]-Clock Select = 100- for prescaler=64 in order to obtain frequency of 1kHz
The concept of Deadtime:
One of the main problems in pulse width modulated voltage source inverter (PWM-VSI) drives is the nonlinear voltage
gain caused by non-ideal characteristics of the power inverter.
The most important nonlinearity is caused by the necessary
blanking time between top and bottom switch to avoid inverter
leg shoot-through of the DC bus circuit. The type of the switch
and pre-driver characteristics determine amount of the
necessary blank time.