minix3/drivers/power/tps65217/tps65217.c

414 lines
9.0 KiB
C
Raw Normal View History

2020-02-21 00:59:27 +05:30
#include <minix/ds.h>
#include <minix/drivers.h>
#include <minix/i2c.h>
#include <minix/i2cdriver.h>
#include <minix/log.h>
#include <sys/signal.h>
/* Register Addresses */
#define CHIPID_REG 0x00
#define PPATH_REG 0x01
#define INT_REG 0x02
#define CHGCONFIG0_REG 0x03
#define CHGCONFIG1_REG 0x04
#define CHGCONFIG2_REG 0x05
#define CHGCONFIG3_REG 0x06
#define WLEDCTRL1_REG 0x07
#define WLEDCTRL2_REG 0x08
#define MUXCTRL_REG 0x09
#define STATUS_REG 0x0a
#define PASSWORD_REG 0x0b
#define PGOOD_REG 0x0c
#define DEFPG_REG 0x0d
#define DEFDCDC1_REG 0x0e
#define DEFDCDC2_REG 0x0f
#define DEFDCDC3_REG 0x10
#define DEFSLEW_REG 0x11
#define DEFLDO1_REG 0x12
#define DEFLDO2_REG 0x13
#define DEFLS1_REG 0x14
#define DEFLS2_REG 0x15
#define ENABLE_REG 0x16
/* no documented register at 0x17 */
#define DEFUVLO_REG 0x18
#define SEQ1_REG 0x19
#define SEQ2_REG 0x1a
#define SEQ3_REG 0x1b
#define SEQ4_REG 0x1c
#define SEQ5_REG 0x1d
#define SEQ6_REG 0x1e
/* Bits and Masks */
/*
* CHIP masks - CHIPID_REG[7:4]
*/
#define TPS65217A_CHIP_MASK 0x70
#define TPS65217B_CHIP_MASK 0xf0
#define TPS65217C_CHIP_MASK 0xe0
#define TPS65217D_CHIP_MASK 0x60
/*
* Interrupt Enable/Disable Bits/Masks - INT_REG[6:4]
* 0=Enable 1=Disable | Default mask: Disable ACM, USBM ~ Enable only PBM
*/
#define PBM_INT_DIS_BIT 6
#define ACM_INT_DIS_BIT 5
#define USBM_INT_DIS_BIT 4
#define DEFAULT_INT_MASK ((1<<ACM_INT_DIS_BIT)|(1<<USBM_INT_DIS_BIT))
/*
* Interrupt Status Bits - INT_REG[3:0]
*/
#define PBI_BIT 2
#define ACI_BIT 1
#define USBI_BIT 0
#define PBI_MASK (1<<PBI_BIT)
/*
* Power Off Bit - STATUS[7]
*/
#define OFF_BIT 7
#define PWR_OFF_MASK (1<<OFF_BIT)
/* The TPS65217 is connected to the NMI pin of the AM335X on the BeagleBone and
* BeagleBone Black. That line is used to signal to the SoC that an interrupt
* has happened in the TPS65217. The NMI pin in turn generates an interrupt
* in the SoC which this driver will receive.
*/
static int irq = 7;
static int irq_hook_id = 7;
static int irq_hook_kernel_id = 7;
/* Only valid slave address for this device is 0x24 */
static i2c_addr_t valid_addrs[2] = {
0x24, 0x00
};
/* the bus that this device is on (counting starting at 1) */
static uint32_t bus;
/* slave address of the device */
static i2c_addr_t address;
/* endpoint for the driver for the bus itself. */
static endpoint_t bus_endpoint;
/* logging - use with log_warn(), log_info(), log_debug(), log_trace(), etc */
static struct log log = {
.name = "tps65217",
.log_level = LEVEL_INFO,
.log_func = default_log
};
/* Device Specific Functions */
static int check_revision(void);
static int enable_pwr_off(void);
static int intr_enable(void);
static int intr_handler(void);
static void do_shutdown(int how);
/* SEF Related Function Prototypes */
static void sef_local_startup(void);
static int sef_cb_lu_state_save(int);
static int lu_state_restore(void);
static int sef_cb_init(int type, sef_init_info_t * info);
static int
check_revision(void)
{
int r;
uint8_t chipid;
r = i2creg_read8(bus_endpoint, address, CHIPID_REG, &chipid);
if (r != OK) {
log_warn(&log, "Failed to read CHIPID\n");
return -1;
}
switch (chipid & 0xf0) {
case TPS65217A_CHIP_MASK:
log_debug(&log, "TPS65217A rev 1.%d\n", (chipid & 0x0f));
break;
case TPS65217B_CHIP_MASK:
log_debug(&log, "TPS65217B rev 1.%d\n", (chipid & 0x0f));
break;
case TPS65217C_CHIP_MASK:
log_debug(&log, "TPS65217C rev 1.%d\n", (chipid & 0x0f));
break;
case TPS65217D_CHIP_MASK:
log_debug(&log, "TPS65217D rev 1.%d\n", (chipid & 0x0f));
break;
default:
log_warn(&log, "Unexpected CHIPID: 0x%x\n", chipid);
return -1;
}
return OK;
}
static int
enable_pwr_off(void)
{
int r;
/* enable power off via the PWR_EN pin. just do the setup here.
* the kernel will do the work to toggle the pin when the
* system is ready to be powered off. Should be called during startup
* so that shutdown(8) can do power-off with reboot().
*/
r = i2creg_write8(bus_endpoint, address, STATUS_REG, PWR_OFF_MASK);
if (r != OK) {
log_warn(&log, "Cannot set power off mask.");
return -1;
}
return r;
}
static int
intr_enable(void)
{
int r;
uint8_t val;
static int policy_set = 0;
static int irq_enabled = 0;
/* Enable IRQ */
if (!policy_set) {
r = sys_irqsetpolicy(irq, 0, &irq_hook_kernel_id);
if (r == OK) {
policy_set = 1;
} else {
log_warn(&log, "Couldn't set irq policy\n");
return -1;
}
}
if (policy_set && !irq_enabled) {
r = sys_irqenable(&irq_hook_kernel_id);
if (r == OK) {
irq_enabled = 1;
} else {
log_warn(&log, "Couldn't enable irq %d (hooked)\n",
irq);
return -1;
}
}
/* Enable/Disable interrupts in the TPS65217 */
r = i2creg_write8(bus_endpoint, address, INT_REG, DEFAULT_INT_MASK);
if (r != OK) {
log_warn(&log, "Failed to set interrupt mask.\n");
return -1;
}
/* Read from the interrupt register to clear any pending interrupts */
r = i2creg_read8(bus_endpoint, address, INT_REG, &val);
if (r != OK) {
log_warn(&log, "Failed to read interrupt register.\n");
return -1;
}
return OK;
}
static int
intr_handler(void)
{
int r;
uint8_t val;
struct tm t;
/* read interrupt register to get interrupt that fired and clear it */
r = i2creg_read8(bus_endpoint, address, INT_REG, &val);
if (r != OK) {
log_warn(&log, "Failed to read interrupt register.\n");
return -1;
}
if ((val & PBI_MASK) != 0) {
log_info(&log, "Power Button Pressed\n");
kill(1, SIGUSR1); /* tell init to powerdwn */
return OK;
}
/* re-enable interrupt */
r = sys_irqenable(&irq_hook_kernel_id);
if (r != OK) {
log_warn(&log, "Unable to renable IRQ (r=%d)\n", r);
return -1;
}
return OK;
}
static int
sef_cb_lu_state_save(int UNUSED(state))
{
ds_publish_u32("bus", bus, DSF_OVERWRITE);
ds_publish_u32("address", address, DSF_OVERWRITE);
return OK;
}
static int
lu_state_restore(void)
{
/* Restore the state. */
u32_t value;
ds_retrieve_u32("bus", &value);
ds_delete_u32("bus");
bus = (int) value;
ds_retrieve_u32("address", &value);
ds_delete_u32("address");
address = (int) value;
return OK;
}
static int
sef_cb_init(int type, sef_init_info_t * UNUSED(info))
{
int r;
if (type == SEF_INIT_LU) {
/* Restore the state. */
lu_state_restore();
}
/* look-up the endpoint for the bus driver */
bus_endpoint = i2cdriver_bus_endpoint(bus);
if (bus_endpoint == 0) {
log_warn(&log, "Couldn't find bus driver.\n");
return EXIT_FAILURE;
}
/* claim the device */
r = i2cdriver_reserve_device(bus_endpoint, address);
if (r != OK) {
log_warn(&log, "Couldn't reserve device 0x%x (r=%d)\n",
address, r);
return EXIT_FAILURE;
}
/* check that the chip / rev is reasonable */
r = check_revision();
if (r != OK) {
/* prevent user from using the driver with a different chip */
log_warn(&log, "Bad CHIPID\n");
return EXIT_FAILURE;
}
/* enable interrupts */
r = intr_enable();
if (r != OK) {
log_warn(&log, "Failed to enable interrupts.\n");
return EXIT_FAILURE;
}
/* enable power-off pin so the kernel can cut power to the SoC */
enable_pwr_off();
if (type != SEF_INIT_LU) {
/* sign up for updates about the i2c bus going down/up */
r = i2cdriver_subscribe_bus_updates(bus);
if (r != OK) {
log_warn(&log, "Couldn't subscribe to bus updates\n");
return EXIT_FAILURE;
}
i2cdriver_announce(bus);
log_debug(&log, "announced\n");
}
return OK;
}
static void
sef_local_startup(void)
{
/*
* Register init callbacks. Use the same function for all event types
*/
sef_setcb_init_fresh(sef_cb_init);
sef_setcb_init_lu(sef_cb_init);
sef_setcb_init_restart(sef_cb_init);
/*
* Register live update callbacks.
*/
/* Agree to update immediately when LU is requested in a valid state. */
sef_setcb_lu_prepare(sef_cb_lu_prepare_always_ready);
/* Support live update starting from any standard state. */
sef_setcb_lu_state_isvalid(sef_cb_lu_state_isvalid_standard);
/* Register a custom routine to save the state. */
sef_setcb_lu_state_save(sef_cb_lu_state_save);
/* Let SEF perform startup. */
sef_startup();
}
int
main(int argc, char *argv[])
{
int r;
message m;
int ipc_status;
env_setargs(argc, argv);
r = i2cdriver_env_parse(&bus, &address, valid_addrs);
if (r < 0) {
log_warn(&log, "Expecting -args 'bus=X address=0xYY'\n");
log_warn(&log, "Example -args 'bus=1 address=0x24'\n");
return EXIT_FAILURE;
} else if (r > 0) {
log_warn(&log,
"Invalid slave address for device, expecting 0x24\n");
return EXIT_FAILURE;
}
sef_local_startup();
while (TRUE) {
/* Receive Message */
r = sef_receive_status(ANY, &m, &ipc_status);
if (r != OK) {
log_warn(&log, "sef_receive_status() failed\n");
continue;
}
log_trace(&log, "Got a message 0x%x from 0x%x\n", m.m_type,
m.m_source);
if (is_ipc_notify(ipc_status)) {
switch (m.m_source) {
case DS_PROC_NR:
/* bus driver changed state, update endpoint */
i2cdriver_handle_bus_update(&bus_endpoint, bus,
address);
break;
case HARDWARE:
intr_handler();
break;
default:
break;
}
/* Do not reply to notifications. */
continue;
}
log_warn(&log, "Ignoring message 0x%x from 0x%x\n", m.m_type,
m.m_source);
}
return 0;
}